Kitchen and Bathroom Faucets
Drips, low flow, stiff handles and leaks at the base usually trace back to a worn cartridge, O ring or clogged aerator. We rebuild the faucet when parts are available, or install a new one you choose.
Faucet and Fixture Repair in Yorba Linda
Faucet dripping all night? Shower handle leaking behind the wall? Shutoff valve under the sink snapped when you turned it? Our faucet repair team in Yorba Linda fixes or replaces faucets, valves, spigots and garbage disposals, usually in one visit, and tells you which option saves you more.
Last updated: October 15, 2026
Call (657) 359-9180
Tell us which fixture is acting up
What we handle
Faucets and Fixtures We Repair in Yorba Linda
From the kitchen sink to the hose bib in the yard, we repair the fixtures your home uses every day.
Shower and Tub Valves
A shower that drips after you turn it off, or a handle that will not set the right temperature, points to the valve cartridge inside the wall. We replace it from the front, so the tile stays put in most cases.
Shutoff Valves
The small angle stops under sinks and toilets often go years without being touched. When they finally get turned, they can leak or break. We replace them with new quarter turn valves.
Laundry and Utility Valves
The hot and cold valves behind the washer can drip or seize. We replace them so you can shut the water off when the hoses need changing.
Outdoor Spigots
Hose bibs crack, leak at the handle or drip nonstop. We repair or replace them and check the line behind the wall.
Garbage Disposals
Jammed, humming, leaking from the bottom or the back. We repair the unit when we can, or install a new one, including one you already bought.
For a leak you cannot see, our leak detection team will find it. For a running toilet, see toilet repair.
How it works
How We Repair a Leaky Faucet
Most faucet repairs take under an hour once we are at the sink.
- 1
Shut the water
We close the shutoff under the sink and test that it holds.
- 2
Find the worn part
We take the handle apart and check the cartridge, seals and aerator.
- 3
Repair or replace
We swap the worn part, or install a new faucet if the old one is failing all over.
- 4
Clean the scale
We clear mineral buildup from the aerator so the flow comes back.
- 5
Test it
We run hot and cold, check for drips and look under the sink for leaks.
Quick answer
Do You Fix Garbage Disposals?
Yes. Yorba Linda Plumbing Pros repairs and replaces garbage disposals, including units that hum without spinning, leak from the bottom or back, or keep tripping the reset button.
A jam can often be cleared on the spot. A leak from the body of the unit usually means it is time for a new one. We can install a disposal you already bought, connect the dishwasher drain and check the trap under the sink so everything drains the right way.
Warning signs
Signs a Fixture Needs Repair
Most fixtures give a warning before they fail. Catching it early keeps a small part swap from turning into water damage.
- A drip that will not stop after the handle is closed
- A stiff or loose handle that is hard to set
- Weak flow at one faucet while the others are fine
- Water under the sink or a damp cabinet floor
- A shower that swings hot and cold when someone flushes
- A spigot that drips or leaks from the handle outside
Pricing
How Much Does Faucet Repair Cost in Yorba Linda?
A typical faucet repair runs about $100 to $250, while a faucet or fixture replacement usually runs about $150 to $600, depending on the fixture you choose and how hard it is to reach. You get the price before any work starts.
What changes the price:
- Repair or replace A cartridge swap costs less than a new faucet.
- The fixture Designer and touchless faucets cost more than basic models.
- Shower valves Work inside the wall takes more time than a sink faucet.
- Seized valves Old shutoffs that will not close add a valve replacement.
- Customer supplied parts We can install a fixture you already bought.
Our upfront pricing means you can pick repair or replacement with both numbers in front of you.
Right now
What to Do When a Shutoff Valve Breaks
A broken valve under a sink can spray hard. A few quick steps keep the water off your floors.
- 1
Shut the main water valve
for the whole house right away.
- 2
Open a faucet
on the lowest level to drain the pressure from the lines.
- 3
Dry the area
and move anything stored under the sink.
- 4
Leave the broken valve alone
so it does not crack further.
- 5
Call a plumber
to replace it with a new quarter turn valve.
Local know how
Why Yorba Linda Water Wears Out Fixtures
Hard water is the main reason faucets and valves wear out early in Yorba Linda. Minerals in the water coat moving parts and seals, so drips and stiff handles show up sooner.
Very hard water
Local well water averages about 20 grains of hardness, and the Yorba Linda Water District relies mostly on groundwater.
Scale on cartridges
Minerals grind on the seals inside faucet and shower cartridges each time the handle moves.
Clogged aerators
Scale collects in the tip of the faucet and slowly cuts the flow.
Valves never turned
In many homes built in the 1970s and 1980s, the original shutoff valves have been sitting still for decades and can fail when finally used.
What we handle
Types of Faucet Cartridges and Valves
Faucets work in one of four main ways, and each one wears out differently. Knowing which type you have tells the plumber which parts to bring.
Most modern kitchen and bathroom faucets use a cartridge or ceramic disc. These last a long time, but hard water scale can still grind on the seals and make a handle stiff or drippy. Older compression faucets drip when their rubber washers harden, which is a simple, low cost repair.
Pressure Balance vs Thermostatic Shower Valves
Shower valves keep the water temperature steady, and there are two main kinds.
A pressure balancing valve reacts to changes in water pressure. If someone flushes a toilet and the cold pressure drops, the valve cuts back the hot water so you do not get scalded. It is the most common type in homes.
A thermostatic valve reacts to the actual water temperature and holds it where you set it, even as pressure changes. It costs more but gives the most stable shower and often lets you set the temperature and the flow separately.
If your shower swings hot and cold, the cartridge inside a pressure balancing valve is often worn or packed with scale. Replacing it from the front usually fixes the problem without touching the tile.
Garbage Disposal Dos and Don'ts
A garbage disposal lasts longer and clogs less when it is used the right way.
Do:
- Run plenty of cold water before, during and after grinding.
- Feed food in small amounts instead of all at once.
- Use the reset button on the bottom if the motor stops.
- Clear a jam with the hex key slot on the bottom, with the power off.
Don't:
- Pour grease or oil down the drain.
- Grind fibrous foods like celery, onion skins or corn husks.
- Put in coffee grounds, eggshells or pasta in large amounts.
- Reach inside with your hand, ever.
If the disposal hums but will not spin, leaks from the bottom or keeps tripping the reset, it likely needs repair or replacement.
Service area
Areas We Serve for Faucet and Fixture Repair in Yorba Linda
We repair faucets and fixtures in homes and businesses across 92885, 92886 and 92887.
- West side homes near the Placentia line, where harder water wears out cartridges faster
- Older streets off Yorba Linda Boulevard, where original shutoff valves are due for replacement
- Townhomes and condos near Yorba Linda Town Center, where a leak can reach the unit below
- Kitchens and restrooms at Savi Ranch businesses, kept working with quick fixture repairs
Any part of town, the same local team.
Why us
Why Choose Us for Faucet and Fixture Repair
Yorba Linda Plumbing Pros fixes most faucets and fixtures in a single visit. For anything bigger, our plumbing company in Yorba Linda handles the whole house.
Repair first
We fix what can be fixed before suggesting something new.
Your choice of fixture
We install the faucet you pick or one we supply.
Upfront pricing
The price is set before the work starts.
Clean work
Under sink cabinets left dry and tidy.
FAQ
Faucet and Fixture Repair FAQs
Straight answers to what Yorba Linda homeowners ask us most. Still unsure? Call and ask a plumber.
Call (657) 359-9180Why does my faucet keep dripping after I shut it off?
A drip after the handle is off almost always means a worn cartridge, washer or seal inside the faucet. Hard water speeds up that wear by leaving scale on the moving parts. Replacing the worn part usually stops the drip. If the faucet body itself is corroded, a new faucet is the better choice.
Can you install a faucet I already bought?
Yes. We are happy to install a faucet, disposal or fixture you already purchased. We check that it fits your sink and connections before we start. If anything is missing, such as new supply lines or a valve, we let you know and give you the price before adding it.
Why is the water pressure low at one faucet?
When only one faucet has weak flow, the aerator at the tip is often clogged with mineral scale. Cleaning or replacing it usually brings the flow back. If the aerator is clean, the cartridge or the shutoff valve under the sink may be partly blocked, and we can repair that too.
How long does it take to replace a faucet?
Replacing a standard kitchen or bathroom faucet usually takes about one to two hours. A shower valve can take longer because the work is inside the wall. If the shutoff valves under the sink are old and need replacing too, we add that time and tell you before we start.
Should I replace old shutoff valves under my sinks?
If your home still has the original shutoff valves, it is a smart idea. Old valves can stick, leak or break when you finally need to use them. Replacing them with modern quarter turn valves means you can stop a leak fast. It is a quick job and is often done during another repair.
Is a leaking garbage disposal worth repairing?
It depends on where it leaks. A leak at the sink flange or the drain connection can often be fixed. A leak from the body or the bottom of the unit usually means the inside seals have failed, and replacing the disposal is the better value. We tell you which it is before any work starts.
How do I know which type of faucet I have?
Look at the handles. Two separate handles that you twist until they stop are usually a compression faucet. A single handle on a round dome is often a ball faucet. A smooth single lever or two smooth handles usually means a cartridge or ceramic disc faucet. A photo of the faucet helps the plumber bring the right parts.
Can a stiff faucet handle be fixed?
Usually, yes. A handle that is hard to turn or lift is often caused by mineral scale on the cartridge or worn seals inside. Cleaning or replacing the cartridge makes the handle move smoothly again. If the faucet is old and the cartridge is no longer made, replacing the whole faucet is often the better value.
Call for Faucet and Fixture Repair in Yorba Linda
A dripping faucet wastes water every hour it runs. Call now, tell us which fixture is acting up, and we will get a plumber out to fix it.